8,720
edits
Changes
m
→Morphing
Multiple (any or all) continuous parameters, including those in the Amp and Cab blocks can be assigned a morph value. While some view this feature as a multiple-parameter gimmick, if nothing else it allows continuous control over ''any'' continuous parameter, greatly expanding the out the box functionality of any expression pedal. Morph values can be set higher or lower than the base value. The expression pedal heel position corresponds to the base value, and the toe position the morphed value.
The morphing procedure with a "morph" pedal connected is to rock the pedal towards the toe position before changing a value. When you change the value, you'll see an "M" appear next to it, so you know this is the full morph value (toe position). If not using a pedal, tap the Rig button. It has a bottom LED and top LED - the LEDs switch when Rig is tapped. The bottom is the base value, and the top is the morphed. So press Rig until the bottom LED is on; set your base parameters; then press Rig so the top LED is on and set your morph parameters. That's all there is to it. The assigned morph pedals or switches will now control those parameters.
Morph settings are saved per rig. To erase a morph for a given parameter, either reset the morph value to match the base value, or sweep the base value through the range of the morph value (if base is 1.0 and morph is 4.0, sweeping the base value from < 1.0 to > 4.0 will clear the morph entirely).