8,720
edits
Changes
m
Top of Page
Top of Page{{top}}
Top of Page{{top}}
Top of Page{{top}}
Top of Page{{top}}
Top of Page{{top}}
Top of Page{{top}}
no edit summary
I have noticed that when using dual amp patches, there can be some comb filtering due to the two signals becoming out of phase. If the cab DEP's included a short variable delay (0 - 10 or 20ms), this could be fixed. I am currently using EQ's to try to achieve phase correction which has very limited accuracy. See this thread.
{{top}}
== Amps ==
Lower the default Master Volume DEP settings for cleaner amps that tend to exhibit crossover distortion. For instance the Blackface Dbl is defaulted to 100%, when it offers no tonal benefit to do so (unless you like crossover distortion). Especially change the Elektrik's MV off of 100% - it sounds like garbage at that setting.
== Utilities ==
Include DSP management tools. Have a DSP meter display how much DSP is currently being used. When selecting a new effect, rather than put it right into the chain causing the DSP error message and blanking out the effect block, display how much more DSP it would take up before you actually add it to the chain.
== Routing ==
The mixer, the end of the signal chain, or even a separate effect should be able to set a very precise, short, and variable delay (0.00 - 5.00 ms)to each side of the signal. This would be useful to achieve phase correction and avoid comb filtering, due to delays introduced into the signals by using different signal chains. Or even add the delay into the biggest offenders, effect-wise. I imagine this would be the most DSP intensive effects, or the ones that require the largest discrete time samples.
== EQ's ==
More control over the footswitch "modes". For instance, I wouldn't mind an all-patch-switch mode, where all 8 footswitches change patches, FS1-4 access patches 2A-2D while FS5-8 access patches 1A-1D for instance. Also, allow the bank up/down switches to be used for next/previous patch, which would be really helpful in pedalboard mode, so you don't have to hit two switches to change patch.
== Effects ==
Allow daily trails through patch switches where enough DSP is available.
== DSP Saving Features ==
If it will use less DSP, make mono versions of the stereo effects. This could particularly help with the Reverbs.
== Devkit ==