8,720
edits
Changes
m
→MIDI Continuous Control
| 48 || 1/0
| Performance Mode: Increases performance index. Value triggers two different modes:
* Value 0, increase performance n to n+1 (bank up)*
* Value 1 initially increases performance by 1, after a timeout the Kemper Profiler starts to scroll performances upwards. Value 0 stops scrolling.
Browse Mode only: Value 0 selects the next Rig (current filter/sort applies), similar to “Rig Right”
| 49 || 1/0
| Performance Mode: Decreases performance index. Value triggers two different modes:
* Value 0, increase performance n to n-1 (bank down)*
* Value 1 initially decreases performance index by 1, after a timeout the Kemper Profiler starts to scroll performances downwards. Value 0 stops scrolling.
Browse Mode only: Value 0 selects the previous Rig (current filter/sort applies), similar to “Rig Left”
| 99 || N/A || Part of an NRPN message; see [[#MIDI NRPN|MIDI NRPN below]]
|}
''* Changing the Performance may or may not load a slot instantly depending on the [[Kemper KPA Performing Live#MIDI|Perf. Load System Menu setting]].''
Most foot controllers support some form of programming what each footswitch will send, and if the footswitch should toggle its value. For example, if you assign FS1 to turn Stomp A on/off, you should be able to set FS1 to light up after pressing it (and it sends a 1 (on) value, indicating you've turned it on. Now if you press it again, the light turns off, and it sends a 0 (off) value.