Changes

This page covers how to physically connect the Pod to your gear and how to setup common settings as well as understand how they work. There's basically two operating modes for the Pod: "direct" or "live". "Direct" means you're connecting to a DAW, PA/mixing board, home stereo, or headphones, and you want the Pod to simulate a mic'ed guitar cabinet. "Live" means you intend to use an actual guitar cabinet/speaker. Note, if you are connecting to a DAW and using an external IR to simulate a mic'ed guitar cabinet, I treat that as a "live" setup, although all the physical connections are the same as a "direct" setup.

The only time I recommend moving the MASTER Knob lower is when you are not using your main rig. By doing this, you are sacrificing tone for ease-of-use. You should gain stage and level your patches as above for your main rig. For other rigs that distort with the amount of volume you're sending them, the easiest way to attenuate the signal is using the Pod's MASTER Knob. Rather than digging into the mixer settings on all of your patches, you can just change one knob and be done for all patches. This may result in additional noise in the signal, but that's acceptable in this case. This applies equally to using headphones.

[[Category:Guitar]]