8,720
edits
Changes
m
no edit summary
With the EQ tools on the Pod, you can't really fine-tune the higher frequencies. You can boost or cut them as a whole, but not dial in or out small frequency ranges. The Parametric EQ's "highs" parameter is a shelf EQ starting at about 1.5kHZ. Setting its frequency parameter at 100% will only get you up to about 4.7 kHZ. The Studio EQ has 3, 5, and 8 kHZ settings for the high frequencies, but it does not have an adjustable Q. The Mid-Focus EQ's low-pass does extend almost all the way to 20 kHZ, but is very sensitive to the frequency control as shown below. Also, you can only cut, not boost. You'll likely have to do a combination the amp model's presence and treble controls, along with some combination of controls just mentioned to fine-tune your high end. Starting with a good cab/mic choice and cab DEP settings is absolutely essential.
=== Graphic EQ ===
I like this mostly for pre-EQ'ing my tone before it hits the amp. I have good control over whether I want more upper or lower mids and can also balance the amount of thump vs. punch, which allows me to thicken the tone without making it muddy. It would also work well to provide final EQ to a clean tone; however, I usually don't use it post-amp on my high gain patches, because I don't have enough bands to fine-tune how I want, at least not for the brighter half of the spectrum. Sometimes I use it to balance the upper and lower mids and punch, though.
=== Parametric EQ ===
The other EQ effect I like to use is the Studio EQ. It gives you two peak/valley controls, each with configurable center frequency and gain, both with a fairly wide Q (~4-6 octaves). I used to like to use it to adjust the very high and low end, but I have discovered the mid-focus actually does this better once you learn how to use it. The main advantage of this EQ is that it has two bands, so for general boost/cuts you can use it and take up less DSP than two Parametric EQs.
=== 4 Band Shift EQ ===
This could potentially be used in conjunction with or to replace the amp EQ controls. Or maybe if you're not using an amp, it would make a good replacement for those. For messing with shift, set it towards 0% if you want the bands to affect the frequencies closer to the mids, 100% if you want them further away. I wouldn't really touch Shift until you've set the other bands, then see if it makes a bit of an improvement. Good Luck!
=== Mid-Focus EQ ===
|}
I recommend starting with Q around 55% and changing frequency to find the spot where you want to trim the high or low end. Then adjust Q and fine-tune frequency. 0% is a very wide, gradual roll-off, whereas 55% is relatively abrupt.
And don't fall into the trap of thinking that EQ will get you everywhere. Amp, cab, and mic selection is just as important. I recommend figuring out which of those have the nuances necessary to get the desired tone before trying to EQ the tone. You'll have to use your imagination, as some of the amps, cabs, and mics have frequency responses FAR from your desired tone. With a little experience, you'll be able to determine what can and cannot be dialed in/out.
== Fizzy Spots ==