8,720
edits
Changes
m
→System Settings
* Rig X-Fade Time - setting this above 0.0 allows cross-fading the volume from one rig to the next, rather than the typical drop-out (however slight) you hear when switching rigs
* Loop Lev. Adj. - you can adjust the volume level of the effects loop send here if your external gear requires alternate gain staging. This is constant across all rigs. Using the Mono Loop vs. Distortion Loop effects give you further flexibility over the send level of the loop. Mono Loop is a constant level, while Distortion Loop factors in the digital volume level of the KPA's virtual signal chain for the placement of the loop effect.
=== External Expression Pedal/Footswitch Setup ===
Pages 5 - 10 cover how expression pedals or footswitches behave. Pedals 1 and 2 cover the two inputs on the back of the KPA, while Pedals 3 - 6 refer to inputs on the official Kemper remote. The Kemper also accepts MIDI CC messages to control its various parameters.
If you only have one expression pedal, you can still use it to do both wah and volume with some additional setup.
=== LFC (Low Frequency Correction) ===