8,720
edits
Changes
m
→Signal Chain Buttons
<small>''Note: This is not always 100% accurate. There are parallel path options for the rig and alternate placement options available for certain blocks.''</small>
Each of these buttons corresponds to a '''block''', which is a discrete form of processing for the signal chain. For instance, a block might hold a particular effect or the simulation of an amplifier. ''Tapping'' any of these buttons will disable/enable that block in the signal chain. (Disabling is equivalent to removing it from the chain.) ''Holding'' a button will bring up the ''edit mode'' for that block. Once a block is selected (edit mode), you can use the [[#Type.2FBrowse_Knobs|Type and Browse knobs (discussed more below)]] to select the desired effect type, profile, or preset. You can return to the home view by pressing the '''Exit''' button to the right of the display.
Below the block buttons for each piece of the signal chain are the 3 buttons '''Stomps''', '''Stack''', and '''Effects'''. These buttons control the entire ''sections'' that encompass the blocks above them. Tapping a section button will disable/enable the entire section. Holding it will bring up its respective edit mode. Each section is covered below: