8,720
edits
Changes
m
→EQ'ing your Patch
The reason I prioritize EQ'ing as described above is in case I run out of effects blocks. If you do run out, you have to start making sacrifices. Rather than cut the ultra low-end, maybe I can just turn down the entire bass range. Maybe the fizzy spot isn't "killing" the tone. This varies tone by tone, but in general I find the fizzy spots are the least noticeable, followed by the ultra high and low end. The most noticeable is if the tone is simply out of balance - with too much presence or too much boominess or honk, etc. Also, try to minimize the number of EQ's you use by making smart choices on which one to use - don't use two Parametric EQ's where one Studio EQ works just as well. Don't use two Studio EQ's where one Graphic EQ works just as well. Using less EQ's usually means more work - it's up to you to determine if the results are worth it.
You've probably also noticed that certain cabs and mics have their own effect on the tone's frequency response. If you run out of EQ blocks or just can't get the desired tone, you may want to try switching these as an alternative method to trying to tweak further. I recommend picking cabs and mics that give you the tonal nuances you desire that likely cannot be dialed with EQ controls, then using EQ controls to give them the general frequency response you desire; however, in some cases this is just not practical. You'll have to make trade-offs. See [[Line 6 Pod HD Cab/Mic Tone|"cab and mic selection" sectionpage]].
Always compare your tone to a sample target, such as a cd, preferably using the same monitoring device (see "monitors" section). This will really tell you if your tone is lacking something. Then you can experiment boosting or cutting different frequency ranges to see if you can get closer. You'll eventually start to identify how certain frequencies alter the feel of a tone and notice if a tone is missing this or that before even comparing it directly.