This is the fifth Kemper Community profile of the Splawn Quick Rod (Phase-05). Amp = Splawn Quick Rod (2011 Model). Speaker = Carvin Legacy 412 Scumback M75 65W 8ohm. Used dual mic's... Shure SM57 & Audio Technical AT4040. SM57 was 2" from the front of the speaker frame, 0.5" from the dome edge, angle = 0deg, level = 0dB. AT4040 was 2" from the front of the speaker frame, 1" from the edge of the dome, angle = 0deg, level = -5dB, Treble = -5 (on the mixer). Mic's were ran into an Allen Heath Mix Wizard 16:2 and then into the KPA. In this session we will compare parallel/series vs. series/parallel wiring of the speakers. Some people say that it makes a difference, some people say it doesn't, I offer no opinion on the subject, I just happen to have a switch on the cabinet so it was easy to compare the two, what do you think? These are the File/Rig names and what they mean: QR5 P/S (parallel/series wiring) QR5 S/P (series/parallel wiring)