HAWP-54 2016-03-19 In this session we will try the amp settings based off of "Mastodon's Bill Kelliher rig" from the photo that Don Petersen posted. I used the same cab and mics as last time, an Avatar Vintage 212 with a V30 and M75, the M75 was mic'd. The mics were an SM57 and a R121. The photo doesn't show the back of the amp so I wasn't sure how the C45, SAT and FAT switches were set. I assume that he didn't use the FAT switch so I profiled the amp with all switches off, then with the C45 on, then with the SAT on and then with the C45 and SAT both on. I made both Studio and Direct Amp profiles and then made Merged profiles. All are included if you want to mess with them. Here are the amp settings: Pres = 6 Bass = 9 (I've never run the bass this high, it's a bit too much for my type of music) Mid = 5.5 Treb = 6 Mast = 7 (this is really-really loud) Gain = 7.5 Note #1: In the photo it looks like the gain is set to 9, the first profile went fine but when I turned the C45 on the profiler said that the amp was too noisy so I turned the gain down a little. Then when I had the SAT and C45 on at the same time the profiler said that the amp was too noisy again so I turned the gain down just a little, I ended up with the gain at about 7.5 when I was done. Note #2: The amp was so loud that the amp started to slide off of the speaker cab, see photos. The speakers were breaking up, I never play this loud, you certainly couldn't play this loud in a small night club without getting arrested :)