Have Amps, Will Profile: BE100 Phase 25 3/16/2015

In this session we will make some DA profiles to LiamThompson's specs.

PLEASE NOTE: these profiles were made with firmware 3.0.1 and should not be used with any firmware lower than 3.0.0.

The amp was loaded down with a Carvin Legacy 412 with Vintage 30's.

Here is LiamThompson's request:
HBE Channel
voice switch R
SAT On
Fat OFF
C45 OFF
Gain 6
Bass 7
Mid 7
Treble 6.5
Presence 6
Master 3.5
Shure SM57 & Audio Technical AT4040.
SM57 was 2" from the front of the speaker frame, 1/2 inch from the edge of the dome, angle = 0deg, level = 0dB.
AT4040 was 2" from the front of the speaker frame, 1" from the edge of the dome, angle = 0deg, level = -5dB, Treble = -5 (on the mixer).
Mic's were ran into an Allen Heath Mix Wizard 16:2 and then into the KPA.

...if you have time another with exactly the same settings but with the mids on 6.
I will compare them to see if there has been much difference between profiling with 2.7 over 3.01.


Here are the file/profile names and what they mean:
====================================================
HAWP25D Mid-6 (Direct Amp profile)
HAWP25D Mid-7 (Direct Amp profile)
HAWP25S Mid-6 (Studio profile)
HAWP25S Mid-7 (Studio profile)