Have Amps, Will Profile: BE100 Phase 22 3/16/2015

In this session we will make some DA profiles to Hallan's specs.

PLEASE NOTE: these profiles were made with firmware 3.0.1 and should not be used with any firmware lower than 3.0.0.

The amp was loaded down with a Carvin Legacy 412 with Vintage 30's.

Here is Hallan's request:
HBE Gain = 4 and 5 and 6
Bass = 6.5
Mid = 4.5
Treb = 7
Pres = 5
Voice Switch = left
FAT = Off
C45 = On
SAT = On
Master Vol = 2.5 and 3.0 and 3.5


Here are the file/profile names and what they mean:
====================================================
HAWP22D HBE-4 M-2.5 (Direct Amp profile, HBE gain = 4, Master Vol = 2.5)
HAWP22D HBE-5 M-2.5 (Direct Amp profile, HBE gain = 5, Master Vol = 2.5)
HAWP22D HBE-6 M-2.5 (Direct Amp profile, HBE gain = 6, Master Vol = 2.5)

HAWP22D HBE-4 M-3.0 (Direct Amp profile, HBE gain = 4, Master Vol = 3.0)
HAWP22D HBE-5 M-3.0 (Direct Amp profile, HBE gain = 5, Master Vol = 3.0)
HAWP22D HBE-6 M-3.0 (Direct Amp profile, HBE gain = 6, Master Vol = 3.0)

HAWP22D HBE-4 M-3.5 (Direct Amp profile, HBE gain = 4, Master Vol = 3.5)
HAWP22D HBE-5 M-3.5 (Direct Amp profile, HBE gain = 5, Master Vol = 3.5)
HAWP22D HBE-6 M-3.5 (Direct Amp profile, HBE gain = 6, Master Vol = 3.5)

PLEASE NOTE:
With this amp the knobs are labled 0, 2, 4, 6, 8, 10, see photo in this folder.
So it is easy to set a knob to 2 or 4,
it's even easy to set a knob to 3 or 5,
but consistantly setting a knob to 2.5 or 3.5 is just about impossible. 
Just FYI in case the gain or whatever doesn't seem exactly right at times.