Have Amps, Will Profile: BE100 Phase 13

In this session we will be trying a few profiles for Hallan,
the request is to try the HBE gain setting at 1, 2 and 3 with the Master Vol at 2.5, 3 and 3.5.

For this test I am using firmware version 2.7.4 Release, the same firmware that I've used for previous HAWP BE100 sessions.

Here are the mic positions and mix:
Shure SM57 & Audio Technical AT4040.
SM57 was 2" from the front of the speaker frame, 1/2 inch from the edge of the dome, angle = 0deg, level = 0dB.
AT4040 was 2" from the front of the speaker frame, 1" from the edge of the dome, angle = 0deg, level = -5dB, Treble = -5 (on the mixer).
Mic's were ran into an Allen Heath Mix Wizard 16:2 and then into the KPA.

Here are the amp settings:
HBE Gain = 1 and 2 and 3
Bass = 6,5
Mid = 4,5
Treb = 7
Pres = 5
Master Vol = 2,5 and 3 and 3,5
Voice Switch = left
FAT = Off
C45 = On
SAT = On

Here are the file names and the meaning:
HAWP13 HBE1 MV2.5 (HBE channel gain 1, Master Volume 2.5)
HAWP13 HBE1 MV3.0 (HBE channel gain 1, Master Volume 3.0)
HAWP13 HBE1 MV3.5 (HBE channel gain 1, Master Volume 3.5)

HAWP13 HBE2 MV2.5 (HBE channel gain 2, Master Volume 2.5)
HAWP13 HBE2 MV3.0 (HBE channel gain 2, Master Volume 3.0)
HAWP13 HBE2 MV3.5 (HBE channel gain 2, Master Volume 3.5)

HAWP13 HBE3 MV2.5 (HBE channel gain 3, Master Volume 2.5)
HAWP13 HBE3 MV3.0 (HBE channel gain 3, Master Volume 3.0)
HAWP13 HBE3 MV3.5 (HBE channel gain 3, Master Volume 3.5)