Have Amps, Will Profile: BE100 Phase 9

In this session we will profile the BE100 using the new DI/Merged profiling. I've been wanting to do this so when LiamThompson asked for a
particular profile with a DI I thought it would be a good time to try one.

For this test I am using firmware version 2.7.4 Release, the same firmware that I've used for previous HAWP BE100 sessions.


PLEASE NOTE:
THIS SESSION INCLUDES THE NEW EXPERIMENTAL PROFILING PROCESS.
THESE PROFILES WERE MADE WITH FIRMWARE VERSION 2.7.4 Release.
THESE PROFILES ARE NOT COMPATABLE WITH OLDER FIRMWARE VERSIONS.
SINCE THIS NEW PROFILING METHOD IS NOT YET OFFICIAL, BY USING THESE PROFILES YOU DO SO AT YOUR OWN RISK.

Based on Liam's request:
All in all if I were to suggest only 1 personal profile setting I’d like if you ever had time,
I would really appreciate the following plus a direct out version would be greatly appreciated.
BE Gain 8 Bass 6 Mid 8 Treb 7 Pres7 Master 4 VR F0 C0 S1 On Axis

Here are the amp settings:
BE Gain = 8
Bass = 6
Mid = 8
Treb = 7
Pres = 7
Master Vol = 4
Voice Switch = Right
FAT = Off
C45 = Off
SAT = On

Here are the mic positions and mix:
Shure SM57 & Audio Technical AT4040.
SM57 was 2" from the front of the speaker frame, 1/2 inch from the edge of the dome, angle = 0deg, level = 0dB.
AT4040 was 2" from the front of the speaker frame, 1" from the edge of the dome, angle = 0deg, level = -5dB, Treble = -5 (on the mixer).
Mic's were ran into an Allen Heath Mix Wizard 16:2 and then into the KPA.

Here are the file names and the meaning:
HAWP9 Full (The full/studio profile)
HAWP9 DI (The DI profile)
HAWP9 MRG (The DI profile with the cab from the full profile merged into it)