Have Amps, Will Profile: BE100 Phase 7

In this session we will profile the BE100 at different master volume settings, all other settings, mic position and mix will stay the same.
The only setting I changed was the mic level to try and keep the input into the KPA at a reasonably constant level as the amp volume increased.

Here are the amp settings:
BE Gain = 7
Bass = 4
Mid = 8
Treb = 7
Pres = 7
Master Vol = 2
Voice Switch = Right
FAT = Off
C45 = Off
SAT = Off

Here are the mic positions and mix:
Shure SM57 & Audio Technical AT4040.
SM57 was 2" from the front of the speaker frame, 1/2 inch from the edge of the dome, angle = 20deg towards the center of the speaker, level = 0dB.
AT4040 was 2" from the front of the speaker frame, 1" from the edge of the dome, angle = 0deg, level = -5dB, Treble = -5 (on the mixer).
Mic's were ran into an Allen Heath Mix Wizard 16:2 and then into the KPA.

I only went to a master volume of 8 because I was worried about the AT4040 handling the SPL. Once I reached 5 it was stupid loud :)

Here are the file names and the meaning:
HAWP7 MSTR-02 (Master volume at 2)
HAWP7 MSTR-03 (Master volume at 3)
HAWP7 MSTR-04 (Master volume at 4)
HAWP7 MSTR-05 (Master volume at 5)
HAWP7 MSTR-06 (Master volume at 6)
HAWP7 MSTR-07 (Master volume at 7)
HAWP7 MSTR-08 (Master volume at 8)